Introduction：
Ruth polymer felt layer mortar is made from
high quality cement, quartz sand and polymer powder imported from
occident. Since the manufacture process is controled by computer,
the polymer mortar is of high quality and excellent properties.
It can be used on the surface layer of exterior wall thermal insulation(extrude
polystyrene) system. Ruth company's annual output of polymer mortar
is 16000 tons. Tested by national authorities, Ruth product shows
superior properties to the national standards.Polymer mortar's strong
felt function can enhance the mechanical strength and durability
of the thermal insulation system.And the dry mortar has advantages
of equal mix, stable quality and easy onsite operation, and so on.
So Ruth polymer felt mortar is widely used on the prime layer of
exterior wall thermal insulation system.
 |
Specification：
| Specification |
Appearance |
Package |
Material |
| Single Component
Polymer Mortar |
Dry Powder |
25 Kg/Bag |
Cement Base |
Application Range：
Can be used on the prime layer of extrude polystyrene exterior
wall thermal insulation system. |
Used on the Wall：
Can be used on all parts of inside and outside
of the building. Such as plaster wall、gypsum board wall、cement board
wall、cement precast board、cement floor，aerated concrate、gypsum or
cement base. Polymer Felt
Mortar Properties：（See JG/T 149－2003 expanded polystyrene thin plaster
exterior wall thermal insulation system）
| Test
Item |
Performance
Index |
Tensile
adhesive strength，Mpa |
Original
Strength |
≥0.60 |
（With
mortar） |
Water resistance |
≥0.40
|
| Tensile adhesive
strength，Mpa |
Original Strength |
≥0.10，destroy interface
on the XPS board |
（With XPS board） |
Water resistance |
≥0.10，destroy interface
on the XPS board |
Operating
Time，h |
1.5～4.0 |
Polymer Felt
Mortar Application Instruction：（For exterior wall thermal
insulation construction）
1、Mix Proportion: 25 Kg/Bag, water:mortar
= 1:5, only add water, no other cement,sand or additional material.
2、Mix method: Prepare a clean barrel, put some water in the barrel,
add in mortar and meanwhile mix them at low speed(below 1000turns/min)
for 3-5 minutes, then put the mixed material aside for 2-3 minutes,
and later mix them for the second time.
3 Construction: Wet the wall before construction if the temperature
is very high or the weather is very dry. Use special made tool to
apply the mortar on the wall or on the XPS boards which have had
interface adhesive agent on them.
4 Application time: Better mix the mortar within 45 minutes, the
maximum use time is 2 hours.
5 Caution: (1) Dried mortar left from last use can not be mixed
again with water or new materials.
(2) Prepare shield against sunlight when the temperature is higher
than 35℃, in order to avoid water dismission when directly exposed
in the sun. Do not construct when the temperature is lower than
4℃.
|
|
|
1、Put in clean water |
2、Add mortar |
3、Mix for 3~5minutes
|
|
|
|
4、Put aside for 2~3 minutes |
5、Mix again |
6、Apply felt mortar |
Caution Matters：
1. Transportation:Avoid extrusion,
impact, rain water, sunlight,etc to ensure application.
2. Loading: load in order, prevent the packages from damage, avoid
toss, impact, or expose in the sun to ensure application.
3. Storage: Prevent from contacting with corrosive, can not be stored
outside; and when stored inside, should keep dry, good vantilation,
and keep away from damp and rain water.
4. Storage time: 6 months in dry place.
|
